Quick guide to the installation of medical beds

With the continuous development of medical technology, medical hospital beds began to be widely used, not only in the hospital, but also in the family can see its figure, very effective in reducing the burden of caregivers. However, many households, after buying a medical hospital bed do not know how to equipment, in order to help us better use, the next article will take us to look at the detailed equipment process of medical hospital beds, expect to bring you assistance.

A. Equipment bed legs

The longer two is the medical bed legs, first remove the screws on the bed legs, the bed legs stuck in the bed board. On, and then re-fix the screws can be. The nuts used in medical beds are anti-loose nuts, do not need to screw too tight, the shorter two are crossbeams, respectively, fixed in the bed legs are now well equipped, quietly shake the bed legs, no loose condition can be.

Second, the equipment casters

Medical hospital beds have two with brake brake, the two casters with brake brake diagonal equipment in the bed frame bed leg screw holes; then the remaining two casters equipment in the remaining two bed leg screw holes.

Third, the equipment convenient hole

The bed hole is composed of three parts: the bed hole structure, the potty frame and the potty hole puller, the potty frame is connected to the bed surface with the transmission rod equipment, and the ball puller is controlled to finish the opening and closing of the potty hole.

Fourth, the equipment bed head bed tail

The headboard of the medical bed is higher, the tailboard is shorter, and the hanging equipment method is selected. The head of the bed hooks aligned with the bed iron pin, buckle the latch can be.

Five, equipment back position gas spring

Push up the back of the bed to 90 degrees, the back of the gas spring with a screw end screwed into the back of the bed at the bottom of the gas spring support seat and then the gas spring under the support seat and the bed with the big frame of the U with the pin connected together, and then use the cotter pin to lock the pin.

Sixth, the equipment guardrail

Align the guardrail frame holes with the bed gang punching orientation, fixed with screws, guardrail switch toward the side of the bed.

Seven, commissioning controller

Motor and push rod in the factory before the equipment has been completed, after the power is connected, through the controller for debugging, the manual has a detailed description of the approach.

Eight, lay the mattress.

If the product supporting special mattress, in accordance with the bed design of Mingtai medical hospital bed, corresponding to the back frame, foot frame and the position of the hole can be.